Description
Euphonycart presents Marshall DSL-40C. Marshall’s DSL40CR is an all-tube, twin-channel workhorse capable of conjuring any classic Marshall sound — past or present. Four ECC83s in the preamp section (in concert with the amp’s gain/master volume arrangement) give you stunning tone-shaping mojo, and with two EL34s in the engine room, you have the volume to rule any club in the world. Sporting the same tubes (minus two EL34s) and feature set as the original DSL100, this little beast has critical upgrades that give you even more control over your sound. A Resonance control (as opposed to the original’s fixed deep switch) lets you dial in your preferred amount of low-end girth. You also get studio-grade digital reverb (instead of spring), high and low power settings, and a bypassable rear-panel series effects loop. Marshall has even included a 2-way footswitch for channel switching and reverb on/off.
Features:
- Capable of conjuring any classic Marshall sound — past or present
- 2 channels — Classic Gain and Ultra Gain
- Each channel features two modes — Clean/Crunch and OD1/OD2, respectively
- High and low power modes allow you to dial in appropriate volume for any setting
- Line output with Softube’s accurate emulation of a Marshall 1960 cab
- Highly effective Resonance control replaces the original’s fixed deep switch
- Refined EQ section gives you incredible tonal flexibility
- Studio-grade digital reverb
- Bypassable rear-panel series effects loop
- Included 2-way footswitch for channel switching and reverb on/off
Tech Specs
- Type:Tube
- Number of Channels:2-channel (2 modes each)
- Total Power:40W (20W power setting)
- Speaker Size:1 x 12″ Celestion V-Type speaker
- Preamp Tubes:4 x ECC83
- Power Tubes:2 x EL34
- Reverb:Classic, Ultra
- EQ:3-band EQ, Tone Shift, Resonance
- Effects Loop:Yes
- Inputs:1 x 1/4″ (instrument), 1 x 1/8″ (aux in)
- Outputs:2 x 1/4″ (4 ohm), 2 x 1/4″ (8 ohm), 1 x 1/4″ (internal 16 ohm speaker), 1 x 1/4″ (Softube emulated out)
- MIDI I/O:In
- Footswitch I/O:1 x 1/4″ (channel, effects loop)
- Footswitch Included:Yes, 2-button footswitch (optional 6-way sold separately)
- Power Source:Standard IEC AC cable
- Height:19.29″
- Width:24.4″
- Depth:9.9″
- Weight:50.4 lbs.
Reviews
There are no reviews yet.